Controls - Rebis Audio RA226 User Manual

CONTROLS:

LEDS: Indicate signal level at the input to the digital section.
Red LED indicates overload.
INPUT: Adjusts the input gain of the unit. (up to +20dBm)
MIX: Output blend control sets a balance between input and output.
FEEDBK: Sets the amount of output signal fed back to the input to
control the number of repeats in delay mode.
PITCH: In playback mode varies the pitch of the sample. Also sets
both the maximum sample and delay time and the bandwidth of the
processed signal.
START: Used to set the beginning point of the sample both in record
and playback modes.
END: Used to set the end point of the sample in record and playback
and the range and length of the delay time.
DELAY: Selects the echo mode ofoperation.On pushing this button
either 2 Seconds or full delay range is selected depending on the posi-
tion of the END control. The associated LED indicates when delay
mode is selected.
REC: Selects the sample mode of operation. When pushed it's associat-
ed LED starts flashing indicating that the unit is waiting for an input
over a preset threshold level. On receiving a signal over this level the
LED illuminates continuously and the input signal is recorded into the
section of memory defined by the positions of the START and END
controls.