Table of Contents
Advertisement
Provision VLANs
Follow the procedures in this section to provision the VLANs on the Cisco 2924M Ethernet Switches
(Hubs). You will need to enter a password to log on to these hubs.
Provision VLANs On Hub A
Follow these steps to provision the VLANs on the Cisco 2924M Ethernet Switch A (Hub A):
Step 1
Connect a console cable to the Hub A console port. Use
machine is designated as Hub A.
Switch> Enter: enable
Step 2
Step 3
The system will prompt you for a password. Enter the password.
Step 4
Switch# Enter: config t
Note
Step 5
Copy the entire config text and paste at the Switch (config)# prompt.
Tip
If you are viewing a pdf file, you can get an electronic copy of this config text using the following
method: Select the "Text Select Tool" (the large "T" in the Adobe Acrobat toolbar above this file). Select
all the config text on this page (Acrobat allows you to copy from only one page at a time.) Use the
Edit/Copy feature (or right click) to get an electronic copy. Paste into a text document. Repeat on the
following pages until you have all the necessary text in your text file. Copy all the text in your text file,
and paste it into your XTerm window.
The config text (for
OL-2906-01
C I S C O C O N F I D E N T I A L
The system will respond with the following prompt: Switch (config)#
Step
5) is as follows. See the Tips paragraph above for assistance with copying:
hostname switch-a
!
interface FastEthernet0/1
description 120-Network Name-Redundancy1
switchport access vlan 146
!
interface FastEthernet0/2
description 120-Network Name-Redundancy1
switchport access vlan 146
!
interface FastEthernet0/3
description 120-Network Name-Redundancy1
switchport access vlan 146
Figure 1 on page 2
to help identify which
Provision VLANs
11
Advertisement
Table of Contents
