Table of Contents
Advertisement
Figure 3
Obtain the 18 Ethernet cables needed for connections between the rear panel of the Call Agents (CA A
Step 3
and CA B) and the two Cisco 2924M Ethernet Switches (Hub A and Hub B). These cables are listed in
Table 1
Step 4
Connect the 18 Ethernet cables to the ports on the rear panel of the CA units as listed in
Appendix B: Cable List, page
Figure 4
Figure 4
Connect CONSOLE Ethernet Cables to Alarm Panel
Connect the two CONSOLE Ethernet cables from the Alarm Panel to the Hubs as described in this
section.
OL-2906-01
C I S C O C O N F I D E N T I A L
Partial Rear View of the EMS Unit Showing Ethernet Ports
EMS (AXi)
in
Appendix B: Cable List, page
23.
shows the rear view of the CA. On the CA, use ports ETH0 and ZNB0 through ZNB7.
Partial Rear View of the CA Unit Showing Ethernet Ports
Call agent (AXmp)
Connect CONSOLE Ethernet Cables to Alarm Panel
23.
Table 1
in
5
Advertisement
Table of Contents
