Table of Contents
Advertisement
Section 4 - ADJUSTMENTS & REPAIR
WARNING
DO NOT attempt any adjustments, maintenance,
service or repairs with the engine running. Stop
engine. Stop blade. Engage parking brake. Remove
key. Remove spark plug wire from spark plug and
secure away from plug. Engine and components are
HOT. Avoid serious burns; allow all parts to cool
before working on machine. Fuel Filler Cap and Vent
must be closed securely to prevent fuel spillage. DO
NOT attempt to service or charge the battery while it
is installed on the YARD CRUISER. Shield the
positive terminal with terminal cover located on
battery harness. This prevents metal from touching
the positive terminal, which could cause sparks.
Cables must be connected to battery terminals in the
proper position as shown.
4.4 MOWER BLADE REPLACEMENT
4.4.3. BLADE REPLACEMENT
1. Remove blade(s). See Figure 4.14. Replace
blade(s) if it shows signs of excessive wear or
damage. Use Part Number 1-9523 for replacement
33" blade.
4.5 BATTERY
4.5.1. BATTERY REMOVAL
1. Tilt seat up to gain access to battery.
2. Observe and note cable positions on battery.
See Figure 4.15.
3. Disconnect
cables
disconnecting
BLACK
Disconnect RED (Positive) battery cable. Slide
battery from battery cradle.
4. Retain mounting bolts and nuts for future use.
4.5.2. BATTERY INSTALLATION
1. Slide battery into battery cradle.
2. Connect cables to battery terminals. Connect
RED
(Positive)
(Negative) cable. See Figure 4.15.
3. Place the positive (+) terminal insulator over
positive terminal and cable. See Figure 4.15.
4.5.3. BATTERY SERVICE
1. Remove battery. Refer to Section "BATTERY
REMOVAL".
2. Place battery in a well-ventilated area on a level
surface.
3. Using distilled water, refill cells as required to
cover cell plates of which can also be visualized
through the plastic battery case.
4. With cell caps removed, connect battery charger
to battery terminals. Red to positive (+) terminal
and black to negative (-) terminal.
from
battery
terminals,
(Negative)
cable
cable
first.
Connect
5. Slow charge battery at 1 amp for 10 hours.
6. If battery will not accept charge or is partially
charged after 10 hours of charging at 1 amp,
replace with new battery, Part Number 6-0753.
BLACK
NEGATIVE (-)
CABLE
The electrolyte (acid) produces a highly explosive gas.
Keep all sparks, flame and fire away from area when
charging battery or when handling electrolyte or battery.
Electrolyte (acid) is a highly corrosive liquid. Wear eye
first.
protection. Wash affected areas immediately after
having eye or skin contact with electrolyte (acid). Battery
acid is corrosive. Rinse empty acid containers with
water and mutilate before discarding. If acid is spilled on
battery, bench, or clothing, etc., Flush with clear water
and neutralize with baking soda. DO NOT attempt to
charge battery while installed on the YARD CRUISER.
BLACK
DO NOT use "BOOST" chargers on the battery. If battery
is removed, DO NOT operate engine without insulating
Positive + battery cable terminal with electrical tape, or
sparking from the battery cables can result.
4.5.4. BATTERY STORAGE
If YARD CRUISER is to be stored out of season on
its rear bumper, it is recommended the battery be
removed, charged and stored.
1. Remove battery. (Refer to Section "BATTERY
REMOVAL").
2. Perform battery service.
3. Bring battery to full charge, if required.
4. Store battery in an area away from the YARD
CRUISER on a wood surface. DO NOT STORE
BATTERY ON A CONCRETE SURFACE.
21
FIGURE 4.15
WARNING
RED
POSITIVE (+)
CABLE
Advertisement
Table of Contents
