Table of Contents
Advertisement
Section 4 - ADJUSTMENTS & REPAIR
WARNING
DO NOT attempt any adjustments, maintenance,
service or repairs with the engine running. Stop
engine. Stop blade. Engage parking brake. Remove
key. Remove spark plug wire from spark plug and
secure away from plug. Engine and components are
HOT. Avoid serious burns; allow all parts to cool
before working on machine. Fuel Filler Cap and Vent
must be closed securely to prevent fuel spillage.
4.2 ENGINE ADJUSTMENTS & REPAIR
Refer to the engine owner's manual for those adjustments
and/or repairs that can be made by the owner.
4.3 MOWER DECK & COMPONENT ADJUSTMENTS
The following mower deck and component adjustments and
repairs can be made by the owner. However, if there is
difficulty in achieving these adjustments and repairs, it is
recommended that these repairs be made by an authorized
SNAPPER dealer.
4.3.1. MOWER DRIVE BELT ADJUSTMENT
The 33" mower deck drive belt does not require any
adjustment. If the belt does not drive blade properly,
replace belt as needed. Refer to Section "BELT
REPLACEMENT". Belt routing shown on this page.
See Figure 4.2.
SPINDLE PULLEY
FIGURE 4.2
4.3.2. MOWER DRIVE BELT REPLACEMENT
Inspect mower drive belt. Replace belt if signs of
excessive wear and/or damage are present.
4.3.3. BELT REMOVAL
1. Remove footrest.
REST REMOVAL".
2. Remove old belt.
4.3.4. BELT REPLACEMENT
1. Route new belt around electric clutch pulley. See
Figure 4.3.
2. Route belt around stationary idler.
3. Remove spring that is connected to idler pulley.
Loosen nut and bolt that secures idler pulley to idler
arm. Route belt between belt guide and idler pulley.
4. Route belt onto spindle pulley. Make sure belt is
inside spindle pulley belt guide.
ELECTRIC
CLUTCH
PULLEY
IDLER PULLEY
Refer to Section "FOOT
BELT REPLACEMENTS
Engine to Hydro Pumps (All Models)
Engine to Electric Clutch (All Models)
Electric Clutch to Mower (33" Decks)
MOWER BELT
ELECTRIC
CLUTCH
VIEW SHOWN FROM UNDERNEATH
WITH DECK REMOVED, DECK REMOVAL
NOT NECESSARY FOR MOWER BELT
REPLACEMENT
5. Reinstall idler pulley spring. See Figure 4.4. NOTE:
The idler belt guide should be positioned so the locator
tab fits into the corresponding hole found on the idler
arm. See Figure 4.4. Tighten bolt securely.
6. Reinstall front frame cover.
IDLER ARM AND BELT
GUIDE DETAIL
MOWER
BELT
STATIONARY
PULLEY
17
Part No. 4-1823
Part No. 2-9117
Part No. 3-5389
ROUTE MOWER BELT AROUND
ELECTRIC CLUTCH PULLEY
FIGURE 4.3
BELT
GUIDE
BELT
GUIDE
FIGURE 4.4
TAB MUST GO
INTO HOLE
LOCATOR
TAB
IDLER
PULLEY
IDLER
ARM
Advertisement
Table of Contents
