Table of Contents
Advertisement
Section 2 - OPERATING INSTRUCTIONS
2.3.5. CUTTING HEIGHT ADJUSTMENT
This machine has seven different cutting height
positions. IMPORTANT: When positioning the cutting
deck into a higher cutting position, pull up on the deck
lift handle only, it is not necessary to pull up on the
release lever at the same time. Use the release lever
when moving deck cutting height to a lower cutting
position.
1. Grasp both handles together to disengage latch.
2. Raise or lower handles to desired height.
3. Release lower handle to engage latch.
See Figure 2.9.
DECK LIFT
HANDLE
RELEASE
LEVER
CONNECTING BAR OMITTED
IN THIS VIEW FOR CLARITY
FIGURE 2.9
HIGHEST
NOTCH
DETENT
PLATE
10
Advertisement
Table of Contents
