Table of Contents
Advertisement
SPECIAL SAFETY RULES
■ Never vacuum up hot ashes or pointed or sharp objects.
■ Never use the appliance in damp rooms.
■ Don't use the appliance without a dust bag (an exception is wet
bag is inserted into the appliance correctly.
■ When using the appliance, make sure that no hair, clothing, or
members are drawn in.
■ Keep the vacuum cleaner away from heat sources such as
radiant heaters, ovens, and so on.
DISPOSAL INFORMATION
■ The appliance contains electric and electronic components and
may not be disposed of as household garbage.
■ The local and currently applicable legislation must be observed
unconditionally.
DESCRIPTION
1. Extension wands (x3)
2. Floor tool
3. Crevice tool
4. Power tool adaptor
5. Hose set
6. Wheels (x4)
7. Handle
8. Foam filter
9. Screws
10. Dust bag
11. Push handle
12. Blowing pot
13. Filter basket
14. Safety float cap
15. Outlet-socket
16. Cartridge filter cap
17. Washable cartridge filter
18. Lock pins (x2)
19. Wheel shaft
20. Hub cap
21. Washers (x2)
22. ON/OFF switch
23. Connection for hose
24. Drain outlet
25. Clamps (x2)
26. Tank
27. Accessory slot
SPECIFICATIONS
Supply voltage:.................................. 230V~,50Hz
Max. power: ...............................................1500W
Power outlet: ...............................................2180W
Tank volume:........................................... 50 l Inox
Hose system: .......................................... Ø35 mm
Filter - dry: ........................ cartridge filter ,dust bag
PACKAGING CONTENT
■ Carefully unpack the contents of the box.
■ Hold the two clamps, which hold the upper section in its
position and fold them upwards.
■ Loosen the clamps, remove the upper section, and remove the
contents from the tank.
■ Please check the parts using the components list to make sure
they are complete and that there has been no damage in trans-
port.
■ If any parts are missing or damaged, then please contact your
dealer immediately.
ASSEMBLY
■ Ensure that the power cord is disconnected from the power
outlet.
■ Undo the clamps (Fig. 2).
■ Lift the top section off the tank (Fig. 3).
■
(Fig. 5).
(Fig. 6).
■
Insert the handle into the slots on the power head and pressure
into place (Fig. 7).
■ F
or dry vacuum cleaning, install the supplied cartridge filter
and dust bag (Fig. 8, Fig. 9).
■
■ Replace the top section on the tank (Fig. 11).
■ Align the top section with the clamps and snap into place by
applying pressure until clamps click (Fig. 11).
■ Insert the large end of the hose into the front inlet of the tank
and turn to lock (Fig. 12).
■ Fit the required accessory on to the suction tube (Fig.13).
OPERATION
DRY VACUUMING
WARNING
Ensure that you read, understand, and apply the safety
instructions.
Reminder: DO NOT vacuum hazardous substances.
The use of an incorrect dust bag will invalidate the warranty.
■ Ensure that the power cord is disconnected from the outlet.
■
■ Verify that the dust bag is installed to the inside of the tank (Fig.
9).
■ Replace the top section on the tank, and secure it in place us-
ing the clamps (Fig. 11).
■ Insert the larger end of the hose into the front inlet on the tank
and lock it in place. Push the required attachment on to the
free end of the hose or extension (Fig.13).
■ Plug the power cord in to the power outlet.
■
(Fig. 15).
■
(OFF) position and unplug the power cord from the power out-
let. (Fig. 16)
WARNING
DO NOT USE THE CARTRIDGE FILTER FOR WET OR
SHARP MATERIALS.
DO NOT USE DUST BAG FOR LIQUID VACUUMING.
8
(Fig. 4).
10).
4
Advertisement
Table of Contents
