Table of Contents
Advertisement
properly and perform its intended function. Check for
alignment of moving parts, binding of moving parts,
breakage of parts, mounting and any other conditions
that may affect its operation.
A guard or other part that is damaged should be
properly repaired or replaced by an authorised
service centre. Following this rule will reduce the risk
of shock, fire or serious injury.
Save these instructions. Refer to them frequently
■
and use them to instruct others who may use this
tool. If you loan someone this tool, loan them these
instructions also.
CHARGER SAFETY
Do not expose charger to wet or damp conditions.
■
Use of an attachment not recommended or sold by
■
the battery charger manufacturer may result in a risk
of fire, electric shock, or injuries to person.
To reduce risk of damage to charger body and
■
cord, pull by charger plug rather than cord when
disconnecting charger.
Make sure cord is located so that it will not be
■
stepped on, tripped over, or otherwise subjected to
damage and stress.
An extension cord should not be used unless
■
absolutely necessary. Use of improper extension
cord could result in a risk of fire and electric shock. If
extension cord must be used, make sure:
a. That pins on plug of extension cord are the same
number, size and shape as those of plug on charger.
b. That extension cord is properly wired and in good
electrical condition.
Do not operate charger with a damaged cord or
■
plug. If damaged, have it replaced immediately by a
qualified serviceman.
Do not operate charger if it has received a sharp
■
blow, been dropped, or otherwise damaged in any
way; take it to a qualified serviceman.
Do not disassemble charger; take it to a qualified
■
serviceman when service or repair is required.
Incorrect reassembly may result in a risk of electric
shock or fire.
To reduce risk of electric shock, unplug the charger
■
from outlet before attempting any maintenance or
cleaning. Turning off controls will not reduce this risk.
Disconnect charger from power supply when not in
■
use.
Risk of electric shock. Do not touch uninsulated
■
portion of output connector or uninsulated battery
terminal.
Save these instructions. Refer to them frequently
■
and use them to instruct others who may use this
unit. If you loan someone this unit, loan them these
instructions also.
SPECIFICATIONS
V
l o
a t
g
e
Air flow volume
Dust storage capacity
W
e
g i
t h
Compatible battery
pack (not included)
Lithium-Ion
BPL-1820
BPL-1815
BPL18202PK
RB18L13
RB18L15
RB18L26
RB18L40
RB18LL40
Nickel
ABP1801G
Cadmium
ABP1802G
ABP-1813
ABP-1815
RB18N15
* for vehicles with 12V DC outlets
OPERATION
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
WARNING:
Always wear safety goggles or safety glasses with
side shields when operating products. Failure to
do so could result in objects being thrown into
your eyes, resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories
not recommended by the manufacturer of this
product. The use of attachments or accessories
not recommended can result in serious personal
injury.
APPLICATIONS
You may use this product for the purposes listed below:
Light-duty vacuuming of dry surfaces.
■
WARNING
Always remove battery pack from your tool when
3
1
8
V
0.83 m
3
/min
650 ml
0
9 .
1
k
g
Compatible charger
(not included)
BCL1418
BCS618
BCL14181H
BCL14183H
BCL1418IV*
BCL1418
BCS618
ACR1800G
260022029
BCL14181H
BCL14183H
BCL1418IV*
Advertisement
Table of Contents
