Sharp PN-HW861 Operation Manual page 31

LED
Specifies whether to light the power LED.
INFORMATION
Displays monitor information.
ALL RESET
Resets the settings to the factory default settings.
TIPS
• When WHITE BALANCE is set to THRU, BLACK LEVEL, CONTRAST, TINT, COLORS, GAMMA, PRESET and USER cannot
be set.
• If COLOR MODE is set to sRGB, the following items cannot be set.
WHITE BALANCE, PRESET, USER, ACTIVE CONTRAST, and GAMMA
• When the COLOR MODE is set to VIVID or HIGH ILLUMINANCE, GAMMA cannot be adjusted.
nSCHEDULE
You can set the time to switch the monitor on and off.
An auto play file in a USB flash drive (see page 26) can also
be played at a specified time. Set INPUT in SCHEDULE to
[USB].
Set this function with SCHEDULE in the SETUP menu. (See
page 29.)
1. Insert the USB flash drive to be played into USB port on
the monitor when playing files. (See page 12.)
2. Press the or button to select the SCHEDULE
number, and press the ENTER button.
3. Set the SCHEDULE. (See below)
Move through the items with the
each item.
4. Press the MENU button.
SCHEDULE becomes effective.
(1) ON/OFF
Enable/disable the SCHEDULE.
(2) ON TIME
Specify the time the power turns on.
Set the time with the , ,
RETURN button.
(3) OFF TIME
Specify the time the power turns off.
Set the time with the , ,
RETURN button.
(4) REPEAT MODES
Select the day of the week the schedule will be executed.
Press the ENTER button to change the setting, and press
the RETURN button.
• ONLY ONCE
The SCHEDULE will be executed once only regardless of
the day of the week. When the schedule is set to ONLY
ONCE, the setting is cleared after the schedule is executed.
• EVERY SUN - EVERY SAT
Executes the SCHEDULE on the specified day every
week.
Multiple days of the week can be specified.
(5) INPUT
Specify the input mode at power on.
or button, and set
or button and press the
or button and press the
Caution
• Do not turn off the main power after setting the SCHEDULE.
• Set the time for both power-on and power-off. The time for
either only cannot be set.
Schedule ON and then OFF only take place in standby
mode and input signal waiting mode.
• Specify the correct date and time. (See page 29.)
SCHEDULE does not function unless the date and time are
specified.
• Check regularly that the set date and time are correct.
TIPS
• Up to 7 SCHEDULE items can be registered.
• Setting the SCHEDULE flashes the power LED alternately
in red and orange in standby mode.
• A SCHEDULE that has a small number has precedence
over that of a large number when schedules overlap.
• POWER SAVE MODE is set to ON, SCHEDULE is
unenabled.
Menu Items
31
E