Table of Contents
Advertisement
Menu Items
SCREEN
AUTO (D-SUB)
The CLOCK, PHASE, H-POS, and V-POS are automatically adjusted.
Pressing the ENTER button performs adjustment. Use this automatic adjustment when you use the D-SUB to display a
computer screen for the first time or when you change the setting of the computer. (See page 32.)
CLOCK (D-SUB)
Adjusts frequency for sampling clock for applicable video.
Adjust when there is flickering in the form of vertical stripes.
When using the adjustment pattern (see page 32), make adjustments so that no vertical stripe noise appears in it.
PHASE (D-SUB)
Adjusts sampling clock phase for applicable video. Useful when small characters appear with low contrast and/or there are
flickers at corners. When using the adjustment pattern (see page 32), make adjustments so that no horizontal stripe noise
appears in it.
* Adjustments to PHASE should be made only after CLOCK has been correctly set.
H-POS (D-SUB)
Adjust the horizontal position of the image.
V-POS (D-SUB)
Adjust the vertical position of the image.
RESET
Resets the values of the SCREEN menu items to the factory default settings.
Select YES and then press the ENTER button.
OPERATION MODE
MODE1 ......OFF IF NO OPERATION is set to ON, and POWER SAVE MODE is set to ON.
(These settings can not be changed.)
MODE2 ......Will perform standard operation. OFF IF NO OPERATION is set to OFF, and POWER SAVE MODE is set to OFF.
These settings can be changed.
POWER SAVE MODE
When OFF is selected, startup time from standby mode is reduced. Note, however, that more power will be consumed in
standby mode.
When ON is selected, current consumption is reduced while the monitor is in standby mode. Note, however, that the startup
time from standby mode becomes longer.
If set to ON, certain RS-232C commands and LAN control cannot be used in standby mode. (See pages 33 and 36.)
OFF IF NO OPERATION
Set whether or not the monitor goes into standby mode when there is no operation from the remote control or RS-232C / LAN.
After setting this to ON, the monitor goes into standby mode when there is no operation for more than 4 hours.
POWER MANAGEMENT
POWER MANAGEMENT determines whether or not to switch modes from no signal to the input signal waiting mode.
NO SIGNAL AUTO INPUT SEL.
Specify whether to change inputs automatically. When ON is selected and no signal is present in the selected input mode, the
monitor automatically changes the selected mode to another mode where a video signal is present.
When video signals exist in multiple input modes, the switching priority is as follows:
USB (when a USB flash drive is connected), HDMI1, HDMI2, HDMI3, D-SUB
(Input mode switching may take 15 seconds or more, depending on the connected equipment. When there are no signals at
any of the input terminals, switching is continued until an input signal is detected and the monitor does not enter input signal
waiting mode.)
AUTO PLAY
Set the type of file to be automatically played from a USB flash drive. (See page 26.)
MONITOR BUTTONS LOCK
You can disable the monitor buttons.
To disable MONITOR BUTTONS LOCK, press the FUNCTION button and then press the
sequence.
REMOTE CONTROL LOCK
You can disable the remote control buttons.
To disable REMOTE CONTROL LOCK, press the FUNCTION button and then press the
sequence. You can also disable REMOTE CONTROL LOCK by turning off the main power, and then turning on the main power
while pressing the POWER button on the monitor. Use this method to disable when auto play has been set in Media Player.
THERMAL SENSOR SETTING
Select the installation direction of the monitor.
LANDSCAPE ............Landscape orientation
PORTRAIT ...............Portrait orientation
30
E
,
,
and
buttons in this
,
,
and
buttons in this
Hide quick links:
Advertisement
Table of Contents
