Table of Contents
Advertisement
Section 4 - REPAIR & ADJUSTMENTS
WARNING
DO NOT attempt any maintenance, adjustments or
service with engine and blade running. STOP engine
and blade. Disconnect spark plug wire and secure
away from spark plug. Engine and components are
HOT. Avoid serious burns, allow sufficient time for
all components to cool.
4.3.3. DRIVEN DISC ADJUSTMENT
(Continued From Previous Page)
2. Remove driven disc spring from driven disc
assembly. Loosen connector hex nut. See Figure 4.9.
DRIVEN DISC
SPRING
TRANSFER
ROD
CONNECTOR
CONNECTOR
HEX NUT
3. Slide driven disc assembly over to 1/8" from
outside edge of drive disc. Maintaining the 1/8"
measurement, remove any looseness from the
linkage. This can be done by holding the transfer rod
and applying pressure to the left (as viewed from
operators position). Then retighten the connector hex
nut securely. See Figure 4.10. Move ground speed
control to the first speed position, then back to the
sixth speed position. Recheck the 1/8" measurement
described previously. Reinstall driven disc spring to
driven disc assembly.
DRIVEN DISC
ASSEMBLY
FIGURE 4.9
SLIDE DRIVEN
DISC ASSEMBLY
TOWARD OUTSIDE
EDGE
TRANSFER
ROD
CONNECTOR
DRIVE
DISC
4.3.4. Replacing Rubber Driven Disc
If the rubber is badly chunked or worn it must be
replaced. Install new Driven Disc as follows:
1. Using a small flat blade screwdriver, free the clip
from the transfer rod. Then remove the transfer rod
from the clip and the speed control rod. See Figure
4.11.
SPEED CONTROL
ROD
15
1/8" MEASUREMENT TO
OUTSIDE EDGE OF DRIVE
DISC
CONNECTOR
HEX NUT
FIGURE 4.10
CONNECTOR
CLIP
FIGURE 4.11
(Continued On Next Page)
DRIVE
DISC
OUTSIDE
EDGE
TRANSFER
ROD
Advertisement
Table of Contents
