JABSCO 36960-2 Series Manual

ELECTRIC BILGE PUMPS
FEATURES
• Self-Priming
• Diaphragm Design Allows Dry Running
• Built-in Hydraulic Pulsation Dampener
• Pumpgard ® Strainer Included with Pump
• Corrosion Resistant Materials Throughout
for Sea Water Service
• Meets USCG Regulation 183.410 and
ISO 8846 MARINE for Ignition Protection
PRODUCT SPECIFICATIONS
Open Flow . . . . . . . . . . . . . . . . . . . . . . . . . . 4.0 GPM
Vertical Dry Suction Lift . . . . . . . . . . . 7 Feet (2.1 m)
Ports . . . . . . . . . . . . . . . . . . . . . . . . 3/4" Slip-on Hose
Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 lb. (3.2 kg)
INSTALLATION
MOUNTING
Mount upright in a dry location (above highest bilge
water level) on a solid surface. Selection of a dry, cool,
ventilated location will generally extend pump life. Locate
Pumpgard strainer in accessible spot in suction hose.
PLUMBING
For intake and discharge use 3/4" ID non-collapsible
hose. Keep intake and discharge line free of kinks and
restrictions. To protect pump from debris, use the 3/4" in-line
strainer, Model 36200-0000 in the intake line from the bilge.
WIRING
Wire pump in a circuit independent of all other electrical
fixtures. Use stranded copper wire. Install fuse in posi-
tive circuit. See table for recommended wire and fuse
size. See diagram for wiring instructions. Use a 10 amp-
rated switch (44960-Series). After installation, it is rec-
ommended that voltage be checked at the motor termi-
nals with motor operating under full load. Voltage should
not be less than 90% of rated motor voitage.
DIMENSIONAL DRAWING
Inches (Millimeters)
7.50 (191)
4.75 (111)
Model 36960-2 Series
STANDARD MODELS
WINTER STORAGE
When possible it is preferred that the complete pump be
removed and stored in a warm dry place. If this is not
possible the pump must be completely drained, hoses
removed and pump run until all water is expelled.
WIRE SIZE TABLE
Wire Length Between 36960-2000 36960-2010
WIRING DIAGRAM FOR
AUTOMATIC OPERATION
7.31
(186)
6.31 (160)
Model Voltage
36960-2000 12 Vdc
36960-2010 24 Vdc
Battery and Motor
1-25 ft.
26-50 ft.
3-Way Switch
44960-0000
FUSE/
BREAKER
BATTERY
Automatic Bilge Switch
Model 34875-0000 or
Model 30295-1000
per instructions
Current Fuse Size
6 Amp 8 Amp
5 Amp 7 Amp
Model Model
12 Volt 24 Volt
12 AWG 14 AWG
10 AWG 14 AWG
MANUAL
OFF
AUTOMATIC
PUMP