Reality View Pro - Navigon 72 Series User Manual

Functions of the map in Navigation mode
When the map is open in Navigation mode, tap any point on the map.
Buttons with various functions will be displayed.
2D/3D: Changes between 2D and 3D mode. The icon indicates the current
mode.
Day/Night: Changes between "Day" and "Night" display modes. The icon
indicates the current mode.
Interim Destination: Opens the menu for entering an interim destination.
The navigation system will first guide you to this interim destination.
Afterwards you can continue your original navigation.
Skip Route Point:Tap this icon to omit the next stage from the list. This button is
active only when at least 2 route points still lie ahead of you. (Refer to
"Multi-leg routes" on page 33)
Block: Tap on this button in order to block a section of the route that lies in front
of you, i.e. to recalculate the route in order to avoid this section, e.g. if
you have heard on the radio of a traffic jam affecting this section. (Refer
to "Block" on page 47)
Tap on this button again to remove the block.
POI on Your Route: Tap on this button to display POI on your route. This way
you can quickly find out, for example, how far it is to the nearest
services. A destination shown here can be added as an interim
destination by tapping the
of its entry in the list.
Note: The categories for the POI on Your Route function are the same
than for the Direct Access function. You can configure which
categories are available. (Refer to "Direct access to POI" on page 27)
6.6.4

Reality View PRO

The map switches to Reality View mode when you approach one of the
following points while driving on the motorway:
a motorway junction
►
a three-leg motorway junction
►
the exit you must take to leave the motorway
►
Navigation
User's manual NAVIGON 72XX
(Interim Destination) button to the right
- 43 -