Water; Fill With Water; Putting Into Service; Electrical Connection - AEG VL 5569 LB Instruction Manual

Standing fan with humidifier
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 39
English
42
NOTE:
• The tank cap on the end of the tube can be turned.
• The water tank must be fitted securely to the base
so that mist cannot escape between the water tank
and the base. If necessary tighten the lower section
of the tube.

Water

• Only use distilled or boiled, cold tap water without addi-
tives.
CAuTION:
Do not fill the water tank with water from clothes dryers
and water with additives (such as scented oils, perfume,
softeners, or other chemicals). Doing so may damage
the appliance.
• Replace the water every 3-4 days, even if it has not yet
been used.
• If the appliance has not used for long periods, remove
the water from the water tank and from the base of the
humidifier.

Fill with water

• Pull the end of the tube with the tank cap out of the water
tank.
• Lift the tank from the base of the humidifier and turn it
over. The filling hole is located on the bottom of the tank.
• Turn the tank cap and fill the water up to ca. 1 centimeter
below the rim. The tank holds around 3 litres.
• Close the cap again and place the tank back onto the
base.
• Place the end of the tube with the tank cap onto the
water tank.
NOTE:
Take note of the recess on the tank cap (see assembly
instruction, item 21).

Putting into Service

Electrical Connection

• Before inserting the plug into the socket. Make sure that
the mains voltage to be used matches that of the device.
You can ind this information on the nameplate.
• Connect the device to a duly installed protective contact
socket. The indicator lamp POWER shows that the power
supply is connected.

Fitting batteries into the remote control

(Batteries not supplied)
• Open the lid of the battery compartment on the rear of
the remote control.
• Insert 2 MICRO batteries of type R03 "AAA" 1.5 V.
• Please ensure the correct polarity. Details can be found in
the battery compartment.
• Close the battery compartment.
NOTE:
If you are not going to use the remote control for a pro-
longed period, remove the batteries in order to prevent
them from leaking.
CAuTION:
• Used batteries should not be disposed of in the
domestic waste. Please return all batteries to a special
collection point. Your local authority will provide you
with information on this.
• Different types of battery or new and used batteries
must not be used together.

remote control range

The remote control has a range of ca. 8 meters. If this range
becomes shorter, the batteries must be changed.
• To use the remote control, point it at the sensor on the
front of the switch housing.
• Make sure there are no obstacles between the remote
control and the sensor.
• The angle of the remote control to the remote control
sensor should not exceed 30° to the right, left, up, and
down.

use

Basic Settings

Set the blower inclination angle before starting the device.
You can adjust the inclination angle by tipping the blower
casing with both hands.
NOTE:
• The inclination angle amounts to approx. 10°.
• The tube above the switch housing must not "sag" due
to the inclination of the blower. Water which collects in
the tube prevents the formation of mist.

Operation

You can operate the appliance using the remote control as
well as the buttons on the switch housing. The functions are
identical.
NOTE:
The LED´s on the switch housing indicate the settings.
ON/OFF
Switch on / off
Use the ON/OFF button to switch the appliance on or off.

Advertisement

Table of Contents
loading

Table of Contents