Handle Height Adjustment; Cutting Height Adjustment - Snapper CP215517HV Safety Instructions & Operator's Manual

Section 2 - OPERATING INSTRUCTIONS

2.4 HANDLE HEIGHT ADJUSTMENT

The height of the mower handle can be adjusted
as follows:
1. Loosen the nuts on each lower handle as
shown in Figure 2.7.
LOWER
HANDLE
FIGURE 2.7
IMPORTANT! Some models are equipped with braces
that attach to the lower handle brackets and must be
loosened before handle height can be adjusted.
2. Move upper mower handle up or down until the
desired position is achieved.
3. Tighten the lower nuts on each lower handle to
maintain desired position.
WARNING
STOP engine and mower blade by releasing the
blade control before adjusting cutting height or
handle height.

2.5 CUTTING HEIGHT ADJUSTMENT

1. Pull the height adjusting latch outward and
move to desired cutting height. See Figure 2.8.
LOWEST CUTTING
1
HEIGHT
1
2
3
HIGHER
LOWER
LOOSEN LOWER
NUTS ON EACH
LOWER HANDLE
LATCH
4
HIGHEST
5
CUTTING
6
HEIGHT
FIGURE 2.8
2. Set all wheels at the same cutting height. The
highest cutting position is Notch 6. The lowest
cutting position is Notch 1. See Figure 2.9.
LATCH
POSITION
S
6
8
CUTTING HEIGHT SETTINGS
FIGURE 2.9