US Robotics MAXg User Manual page 23

Wireless MAXg PC Card and PCI Adapter User Guide
III. Double-click the appropriate wireless networking device and
click Next .
Note: If you are looking for a specific wireless networking
device and do not see it listed, click Detect and your Wireless
MAXg PCI Adapter will search the area again for available
wireless networking devices.
IV. After selecting a wireless networking device, configuration
information for that device will appear. If the network specified
is not secure, the " Install Complete " screen will appear. Click
Finish. If you have specific security settings enabled on the
device you will be connecting to, such as WEP or WPA2, you will
need to select your security type and click Next. Enter the
appropriate security information on the next screen and click
Next.
V. You will then need to enter the User name and Password for
the wireless device you are connecting to. After entering these,
click Next .
VI. When prompted, select Yes, I want to restart my computer
now. and click Finish.
If you experience any problems connecting to a wireless networking
device, refer to the Troubleshooting section in this guide or to the
Configuration section of the User Guide on the U.S. Robotics
Installation CD-ROM for more information.
It is recommended that you enable WEP so that your wireless
network is secure. Make sure you assign the same secret WEP key
to all your wireless devices to ensure future connectivity. For more
information about this and additional wireless parameters, refer to
the User Guide on the U.S. Robotics Installation CD-ROM.
C o n g r a t u l a t i o n s !
You have finished installing your hardware and your drivers! The
Wireless MAXg PC Card will connect to an existing wireless network
or other wireless networking products in the area.
file://D:\Data\USR\Certificate%20document\G-Force%20PC-PCI%20User%20Guide%2012...
第 6 頁，共 7 頁
2004/12/20