How To Run A Wash Cycle; Daily Use - Electrolux WASL 3 T User Manual

38 electrolux
Use
• Your appliance is intended for normal do-
mestic use. Do not use the appliance for
commercial or industrial purposes or for
any other purpose.
• Refer to the instructions on the label of
each item before washing.
• Do not put items into the washing ma-
chine which have had stains removed
with petrol, alcohol, trichlorethylen etc. If
such stain removers have been used,
wait until the product has evaporated be-
fore putting these items into the drum.
PERSONALISATION
Child safety
This option provides two types of locking :
• if the option is activated after the cycle
has started, no changes to the options or
programme is possible.
The cycle runs and you must deactivate
the option to run a new cycle.
• if the option is activated before the cycle
has started, the appliance cannot be star-
ted.
To activate child safety, turn appliance on
and press "Rinse plus"
simultaneously until the confirmation
symbol shows on in the display. The ap-

HOW TO RUN A WASH CYCLE?

Using for the first time
• Ensure the electrical and water con-
nections comply with the installation
instructions.
• Remove the polystyrene insert and
all other items inside the drum.

DAILY USE

Loading washing
• Open the lid of
the appliance.
• Open the drum
by depressing
the locking but-
ton A: The two
shutters unlock
automatically.
• Load the wash-
ing, close the
drum and the lid of your washing machine.
and "Delay start"
A
• Empty pockets and unfold items.
• This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge, un-
less they have been given supervision or
instruction concerning use of the appli-
ance by a person responsible for their
safety.
Children should be supervised to ensure
that they do not play with the appliance.
pliance memorises the selection of this op-
tion. To deactivate child safety, repeat the
process.
Audible signal
When the audible signal is activated, it
sounds when a button is pressed, at the
end of the programme, to indicate a fault.
To deactivate, turn appliance on and press
"Prewash" and "Rinse plus"
neously until the beep sounds. The signal is
only active if alarm sounds. To reactivate it,
repeat the same process.
• Run an initial wash cycle at 90°C,
without any washing but with deter-
gent to clean the water tank.
Warning! Before closing the lid of your
appliance, ensure that the drum is
properly closed :
• When the two shutters are closed,
• locking button A released.
Proportioning of detergents
Pour the amount of washing powder into
the washing and prewash
ments if you have selected the "prewash"
option. Pour fabric softener into the com-
partment if necessary.
simulta-
compart-