Advertisement
Quick Links
Advertisement
Related Manuals for Tesla Model S Roof Rack
Summary of Contents for Tesla Model S Roof Rack
- Page 1 Model S Roof Rack...
- Page 2 clip tool 10. wingnuts 2. hex wrench 11. clips 3. rear crossbar 12. anti-abrasion tape (front driver side) 4. front crossbar 13. anti-abrasion tape (front passenger side) 5. front driver side pad 14. anti-abrasion tape (rear drivers side) 6. front passenger side pad 15.
- Page 3 Thoroughly clean vehicle’s rooftop around the location of the arrows on the glass. Use the icon on the footpads (5-8) to help identify the appropriate position on the vehicle and match anti-abrasion tape (12-15) to footpad (5-8). To locate the front arrows measure 310mm from the front edge of the glass top 310mm...
- Page 4 To locate the rear arrows measure 279mm from the rear edge of the glass top. 279mm Apply (12) anti-abrasion tape to the front driver side of the vehicle by aligning the arrow on the glass with the arrow on the anti-abrasion tape (12), and aligning the edge of the tape with the edge of the trim line.
- Page 5 Keeping the clip tool in place, insert a clip (11) at the arrow location. Remove the clip tool (1), being sure the clip (11) is engaged in the metal receiver under the glass. Pull up and wiggle to be sure it’s properly engaged. Be sure the center of hook aligns with the arrow Repeat steps 4 to 6 to install a clip (11) on the other three corners of the car.
- Page 6 CROSSBAR INSTALLATION: Ensure all four clips are engaged, properly aligned (step 5-6), and in the upright position. Then, carefully place the front and rear crossbars (3-4) over the pads. Install the wingnut (10) and hand tighten onto each of the towers. Tighten the wingnuts with the hex wrench vehicle.
- Page 7 Use the key (9) to lock each tower. Test that the front and rear crossbars are securely installed by pulling vigorously in all directions. Install covers. Start with the bottom edge then press the top into place.
- Page 8 Model S Roof Rack Owner’s Manual...