DeWalt DW080LRS User Manual page 11

Contents
• Laser Information
• User Safety
• Batteries and Power
• Operating Tips
• Turning the Laser On
• Checking the Calibration
• Using the Laser
• Controlling the Laser Remotely
• Accessories
• Maintenance
• Troubleshooting
• Service and Repairs
• Specifications
Laser Information
The DW080LRS/LGS Cordless Rotary Laser is a CLASS 3R laser product and
complies with 21 CFR 1040.10 and 1040.11 except for deviations pursuant to
laser notice No. 50, dated June 24, 2007.
Conforms to UL STDS 61010-1 & 2595
Certified to CSA STD C22.2 No. 61010-1
Complies with IEC 60825-1:2014
These devices comply with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: 1) this device may not cause harmful interference, and
2) this device must accept any interference received, including interference that
may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio and television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit differentfrom that which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Canada, Industry Canada (IC) Notices
Class B digital circuitry of this device complies with Canadian ICES-003.
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: 1) this device may not
cause interference, and 2) this device must accept any interference, including
interference that may cause undesired operation of the device.
READ ALL INSTRUCTIONS
User Safety
Safety Guidelines
The definitions below describe the level of severity for each signal word. Please
read the manual and pay attention to these symbols.
DANGER: Indicates an imminently hazardous situation which, if not
avoided, will result in death or serious injury.
WARNING: Indicates a potentially hazardous situation which, if not
avoided, could result in death or serious injury.
CAUTION: Indicates a potentially hazardous situation which, if not
avoided, may result in minor or moderate injury.
NOTICE: Indicates a practice not related to personal injury which, if not
avoided, may result in property damage.
If you have any questions or comments about this or any
to http://www.D
WARNING:
Read and understand all instructions. Failure to follow the warnings
and instructions in this manual may result in serious personal injury.
SAVE THESE INSTRUCTIONS
WARNING:
Laser Radiation Exposure. Do not disassemble or modify the
laser level. There are no user serviceable parts inside. Serious
eye injury could result.
WARNING:
Hazardous Radiation. Use of controls or adjustments, or
performance of procedures, other than those specified herein may
result in hazardous radiation exposure.
D WALT tool, go
®
E
WALT.com.
E
E
11