Advertisement
Tube and Latch Kit
A
B
Figure 5. Drill Hole In Boot
A. New 11/32" Hole
B. Existing Hole
C. Boot
C
Figure 6. Install Puck to Boot
A. Boot
B. Puck, Metal
C. Capscrew, Thin Head, 5/16-18 x 3/4
D. Locknuts 5/16-18
4. Drill a new 11/32 hole (A, Figure 5) 2" from the exist-
ing hole (B) in boot (C) as shown.
5. Secure the puck (B, Figure 6) to boot (A) using 5/16-
18 x 3/4 capscrew (C) and 5/16-18 locknut (D).
6. Remove and discard the latch (B, Figure 7) from the
cover assembly (A). Remove and retain #10-24 x 5/8
screws (D) and #10-24 locknuts (C).
7. Install the new latch (B, Figure 8) to the cover assem-
bly (A) securing with Existing #10-24 x 5/8 screws (D)
and #10-24 locknuts (C) as shown.
Drill 11/32"
Hole Here
2"
C
B
D
A
A
Figure 7. Remove Latch
A. Cover Assembly
B. Latch
C. Locknuts, Nylock, #10-24
D. Screws, #10-24 x 5/8
A
Figure 8. Install Latch
A. Cover Assembly
B. Latch (New)
C. Locknuts, ESNA, #10-24 (Existing)
D. Screws, #10-24 x 5/8 (Existing)
3
Installation Instructions
C
D
C
D
B
B
Advertisement
