Warranty - Multivet Spray Commander Instruction Manual

2. Place a new battery into the receiver collar. Fill the device, then turn it on.
3. Press button 1 on the remote control; the receiver collar should emit a beep.
4. Press buttons 2 and 3; the receiver collar should release a small spray (button
2), and a large one (button 3). If nothing happens when pressing buttons 1, 2
or 3, there may be a problem with either the transmitter or the receiver circuits.
Please contact our customer service.
5. If any of the 3 buttons produces a reaction in the receiver collar, then the
transmitter is working.
6. However, if no spray is released with buttons 2 and 3, but button 1 activates
the sound signal, then the batteries could be low, or the device may not be
fi lled properly. If all is fi ne in both cases, then there could be a problem with the
spraying mechanism on the receiver collar.
7. If both spray buttons work, but no sound signal can be heard when pressing
button 1, then the piezo buzzer may be faulty. Please contact our customer
service.
8. If the device doesn't seem to hold its contents, or gas can be heard leaking
from the collar, please contact our customer service.

WARRANTY

• The Spray Commander system, carries a warranty that covers against all
manufacturing defects in materials and workmanship for a period of 12 months
starting on the date of purchase. This warranty is limited to repair or replacement,
at option of manufacturer.
• Accessories such as straps, spray refi ll cans, batteries and packaging are not
covered under this warranty.
• The purchaser must complete, date, stamp, and return the warranty card within
fi fteen (15) days of purchase. Note: The warranty can also be completed on-line
at www.multivet-inter.com.
• The warranty may be voided if:
The warranty card was not duly completed, dated, stamped and returned
with proof of purchase within fi fteen (15) days of purchase;