Filling The Device; Inserting The Battery - Multivet Spray Commander Instruction Manual

Your dog must get used to the device before you actually start using it. We suggest
that you make your dog wear the spray device during 4 to 5 days before inserting
the battery and fi lling the device. At the same time, we also suggest that you remove
and put the collar back frequently on your dog.

Filling the device

1. Set the device on a fl at surface, with the fi ll-up valve turned upwards. Shake the
spray can before using it.
A
2. Hold the can upside down, then insert the aerosol tip in the fi ll-up valve – the
deepest cavity (A) – then press down fi rmly for 10 seconds (B). Release pressure
and press down for another 10 seconds, then release.
Note:
If spray is escaping as you attempt to fi ll the device, increase the downward pressure on
the refi ll can to get a better seal. You cannot overfi ll the device. When completely fi lled, there
should be enough gas in your device for 18-23 sprays.

Inserting the battery

1. Slide off the battery cover from the spray device and insert one 6-volt alkaline
battery without forcing it, keeping the polarity in mind (+ and -) (A, B). Slide the
cover back on.
2. Slide off the battery cover from the remote control and insert one 6-volt alkaline
battery, respecting polarity (+ and -) (C, D). Slide the cover back on.
A
B
B C D