Changing Over The Door Hinges - AEG SANTO Series Operating Instructions Manual

e.g.:
(i.e. 220 to 230 volts alternating current, 50 Hertz)
The rating plate is inside the appliance at the left.
Warning: To avoid potential danger, if the mains connection lead of
this appliance is damaged, it must be replaced by our customer service
representative or a person with similar qualifications.

Changing Over The Door Hinges

The door hinges can be changed from right (as supplied) to left if requi-
red to suit the location where the appliance is installed.
1
Warning! The appliance must not be plugged into the mains when the
door hinges are being changed over. Unplug from the mains first.
0 Open the freezer compartment
door and remove the pedestal
cover to the front. Move the door
bearing cover on the pedestal
cover from the left to the right.
0 With the freezer compartment
door closed, remove the cross-head
screws from the lower door bearing
and remove the door bearing
downwards.
Using a 10 mm flat wrench,
unscrew the door bolt from the
lower right-hand side of the
freezer compartment door and
screw it in again on the opposite
side.
0 Remove freezer compartment door
carefully to the front and set aside.
0 Unscrew the centre door bearing.
0 Remove the fridge compartment
door carefully to the front and
place on one side.
40
AC 220 ... 230 V 50 Hz or
220 ... 230 V~50 Hz