What To Do If; Correcting Malfunctions - AEG SANTO Series Operating Instructions Manual

What to do if ...

Correcting Malfunctions

Perhaps a malfunction has been caused by a minor error, which you can
correct yourself with the help of the following instructions. Do not
attempt any further repairs if the following instructions do not help in
each specific case.
1
Warning! Refrigerators/freezers may only be repaired by trained
personnel. Repairs carried out by untrained personnel can lead to
substantial danger for the user. Please contact your dealer or our
customer service department for repairs.
Malfunction
The appliance is not
working, and the
temperature display is dark.
Warning tone sounds, red
warning display is flashing,
doors are closed.
Temperature display shows
a square.
Appliance cools too much.
56
Possible cause
Appliance is not switched
on.
Mains plug is not inserted
or is loose.
Fuse has blown or is defec-
tive.
Mains socket is defective.
Temperature warning for
freezer.
There is a function fault.
Temperature is set too cold.
Dynamic Air Cooling sys-
tem is switched on.
Remedy
Switch appliance on.
Insert mains plug.
Check fuse, replace if
necessary.
Mains malfunctions are to
be corrected by an electri-
cian.
Please check in "Control
and Information System"
section.
Please inform customer
service. Do not open the
doors of the appliance
again.
Turn the temperature to a
warmer setting temporar-
ily.
Turn the temperature to a
warmer setting while the
Dynamic Air Cooling sys-
tem is switched on.