Changing Over The Freezer Compartment Door; Prior To Initial Start-Up; Electrical Connection - AEG SANTO 1583-7 TK Operating Instructions Manual

Changing over the freezer compartment door

Open the freezer compartment door a little way.
Using a small screwdriver, press the spring
in the opening of the lower door bearing
slightly upwards and take the door bearing
out complete with the door.
Position the covering cap (M) on the
opposite side.
Turn the freezer compartment door
through 180° and fit the lower door
bearing into the lower bearing cavity
of the freezer compartment door.
Lift the freezer compartment door a
little way upwards, fit it into the upper
door bearing, and at the same time
insert the lower door bearing into the
square hole.
Small upwards and downwards adjustments of the freezer compart-
ment door will make fitting easier.
Prior to Initial Start–Up
Please clean the appliance interior and all accessories prior to initial
start-up (see section: "Cleaning and Care").

Electrical Connection

Any electrical work required to install this appliance should be carried
out by a qualified electrician or competent person.
WARNING – THIS APPLIANCE MUST BE EARTHED
The manufacturer declines any liability should these safety mea-
sures not be observed.
Before switching on, make sure the electricity supply voltage is the
same as that indicated on the appliance rating plate. The rating plate is
inside, on the left.
10
M
AEG43