Table of Contents
Advertisement
ThinkSystem 1610-4P NVMe Switch Adapter Installation and User Guide
February 28, 2018
Figure 4 Replacing the Bracket
5.
Use an ESD-safe No. 1 Phillip screwdriver to set the screws to a maximum torque of 4.8 ± 0.5 inch pounds to
replace the two Phillips screws that you removed in step 2.
6.
Replace the board in its ESD-protective bag and seal the bag appropriately.
1.4
Driver Installation
You do not have to download a device driver for the ThinkSystem 1610-4P NVMe switch adapter. This product uses
inbox drivers for Microsoft, Linux, and VMWare. For Windows operating systems, use inf (a dummy driver) to make the
yellow bang symbol disappear.
ATTENTION
Exceeding this torque specification can damage the board,
connectors, or screws, and can void the warranty on the board.
3_03570
- 7 -
Chapter 1: Hardware Installation
Driver Installation
Advertisement
Table of Contents
