Table of Contents
Advertisement
ThinkSystem 1610-4P NVMe Switch Adapter Installation and User Guide
February 28, 2018
Chapter 1: Hardware Installation
1.1
Requirements
The following items are required for installation:
A ThinkSystem 1610-4P Non-Volatile Memory Express (NVMe) switch adapter
A host system with an available x16 PCI Express (PCIe) expansion slot
The ThinkSystem Storage Adapters Software User Guide
The necessary internal cables to connect between the NVMe Solid State Devices (SSDs) and the backplane
NVMe SSDs
1.2
Hardware Installation Instructions
To install the ThinkSystem 1610-4P NVMe switch adapter, follow these steps:
1.
Unpack the adapter, and inspect it for damage. Unpack the adapter in a static-free environment. Remove the
adapter from the anti-static bag, and carefully inspect the device for damage. If you notice any damage, contact
Lenovo or your reseller support representative.
2.
Prepare the computer. Turn off the computer, and disconnect the power cord from the rear of the power supply.
3.
Remove the cover from the chassis.
4.
Insert the adapter into an available PCIe slot. Locate an empty x16 PCIe slot adequate for your board. Remove
the blank bracket panel on the rear of the computer that aligns with the empty PCIe slot. Save this bracket screw,
if applicable. Align the adapter to a PCIe slot. Press down gently, but firmly, to seat the adapter correctly in the slot.
The following figure shows how to insert the adapter into a PCIe slot.
ATTENTION
To avoid the risk of data loss, back up your data before you change
your system configuration.
CAUTION
Disconnect the computer from the power supply or you risk damaging
the system or experiencing electrical shock.
NOTE
The shape, size, and locations of the components on your adapter and
its bracket might vary from this illustration. Depending on the
available slot you select, you might need to change the bracket
installed on the adapter. The adapter requires an x16 PCIe slot.
- 4 -
Chapter 1: Hardware Installation
Requirements
Advertisement
Table of Contents
