Regular Cleaning; How To Change The Bulb - AEG SK 98843-6I Instruction Book

It is recommended to operate the appliance at the highest position of the
thermostatic control so that it can reach the proper storing temperature as
soon as possible.

Regular cleaning

It is recommended to wash the inside of the refrigerator in 3-4 weeks time.
Household cleaner or soap must not be used.
After you made it no-current wash the appliance using lukewarm water and
wipe it.
Clean the magnet door rubber profile with clean water.
After cleaning plug the appliance to the mains socket.
It is practical to clean and defrost the frozen food compartment at a time
and when it is empty.
Dust and dirt collected on the back of the refrigerator and the condenser
should be removed once or twice a year. At the same time, the evaporative
tray on top of the compressor should be cleaned as well.
When the refrigerator is not in use
In case the appliance will not be used for a long time follow these steps:
Break the circuit of the appliance.
Remove foods from the refrigerator.
Defrost and clean it as written before.
Leave the door open to avoid a build up of air inside.

How to change the bulb

1. Break the circuit of the appliance.
2. Unscrew the lamp cover securing screw.
3. Unhook the moving part by pressing it as shown in the figure.
4. Replace the bulb with one of
the same power (the maximum
power is shown on the light
bulb cover)
5. Fix the lamp cover in place.
6. Screw the lamp cover securing
screw.
7. Reconnect the appliance.
8. Open the door and check if the
light comes on.
55