Advertisement
tape tightly.
11)
Turn the Mode SW of the Unwinder Control Box to the Low Speed Drive Mode.
12)
Push the Low Speed Drive button of the Unwinder Control Box, then roll paper will be driven
slowly until the connected position will be exited from the Paper Exit.
13)
Turn the Mode SW of the Unwinder Control Box to the Print Mode position, then the machine is
ready to print.
NOTE: Data of incomplete job will be lost. It must be reprint.
1.4.3.
Change of the Paper Cut Size
1) Set two blades when size of the desired output paper is LETTER/A4.
2) Set one blade when size of the desired output paper is LEDGER/A3.
3) Make sure to use the proper position of the blade for LEDGER/A3, otherwise output paper will not be cut
properly.
4) Select the lever of Paper Exit unit for the proper paper size.
5) Select the proper paper size on the Touch Panel. (It is not necessary to set the operation panel.)
NOTE: Refer to EXHIBIT D PINNACLE DIE CUTTER for the detail.
OLYMPUS Industrial Web Printer Operation Guide Rev.001
14/19
Advertisement
