Advertisement
ASSEMBLY INSTRUCTIONS
Note: Make sure that you remove all the contents
from the package. Please check the packaging
materials for parts that could be required to
operate your fan.
Tools required: Small screwdriver.
Base assembly (FIG 2)
1.
Insert the single rear clip of the fan stem into
the hole located at the rear of the fan base.
Push firmly to ensure a secure fit.
2.
Insert the two front clips of the fan stem into
the two holes located at the front of the fan
base, and push firmly to secure.
3.
Set the fan base on a level surface.
Rear grille assembly (FIG 3/4)
1.
Position the rear grille
Make sure that the two holes at the top and one
hole at the bottom of the rear grille fit over the
prongs on the front of the fan head.
2.
Fit the rear grille locking ring
firmly.
3.
If not already done, clip the grille ring
the rear grille. You may need to loosen the grille
securing screw
I
this.
Fan blade assembly (FIG 5)
1.
Slide the fan blade
Ensure that the two notches in the fan fit over
the pin in the motor shaft.
2.
Fit the fan blade lock nut
counter clockwise direction. Tighten it firmly
by hand.
Front grille assembly (FIG 6)
1.
Position the front grille
BIONAIRE logo is the right way up when
viewed from the front.
2.
Attach the front grille to the rear grille
assembly by fitting it into the grille ring
Press into place firmly.
3.
Tighten the grille securing screw
screwdriver to lock the front and rear grilles
together.
OPERATING INSTRUCTIONS
1.
Set your fan on a dry, level surface.
2.
Make sure the on/off and speed control
in the off position (fully counter clockwise).
3.
Plug your fan into a suitable mains outlet
socket.
over the motor shaft.
F
and tighten
D
onto
E
with the screwdriver to do
onto the motor shaft.
C
by turning it in a
B
so that the
A
E
with the
I
L
4.
Turn the on/off and speed control to the
desired speed by turning clockwise. The
speed indicator
the speed selected.
5.
If desired, you can set your fan to swing
slowly backwards and forwards by pressing
the Oscillation button
oscillation, pull the button up.
Fan head tilt adjustment
To adjust the angle of the fan head, hold the base
securely and tilt the fan head to the desired angle.
CLEANING AND MAINTENANCE
Follow these instructions to correctly and safely
care for your fan. Please remember:
•
Always unplug the fan before cleaning or
assembly.
•
Never immerse any part of the appliance or
power cord and plug in water or any other
liquid.
•
Do not allow water to drip onto or into the fan
head.
•
Be sure to use a soft cloth, moistened with a
mild soap solution.
•
Do not use any of the following as a cleaner:
petrol, thinners or benzene.
Fan blade cleaning
To access the fan blade:
1.
Remove the front grille by first loosening the
grille securing screw
the front grille from the rear grille.
2.
Loosen the fan blade lock nut
in a clockwise direction and remove the fan
blade from the motor shaft.
3.
Clean the fan blade, and front and rear grilles
with a soft moist cloth.
4.
Replace the fan blade as described under
Fan blade assembly.
5.
Refit the front grille as described under Front
.
grille assembly.
Fan head and base cleaning
Carefully clean the fan base and fan head using
a soft, moist cloth, with or without a mild soap
solution. Please use caution around the motor
housing area. Do not allow the motor or other
electrical components to become exposed to
water.
is
3
will light up according to
K
down. To stop
H
and then removing
I
by turning it
B
Advertisement
