Advertisement
Available languages
Available languages
vertically (see figure 1).
3. The installation plate must be installed using the
appropriate anchoring hardware and/or fastener for
the wall surface application.
CAREFULLY check fan for proper mounting.
FAN HEAD ASSEMBLY
You are now ready to assemble the fan head.
1. Remove plastic sleeve on motor shaft, if included.
Position the rear grill over the motor shaft, making
certain the 2 notches at the top and 1 notch at
the bottom of the rear grill fit over the protruding
notches on the motor housing. Make sure the rear
grill fits securely against the motor housing.
2. Fasten the rear grill in place using the rear grill nut.
Turn the nut clockwise and tighten firmly.
3. Slide the fan blade, with the hollowed interior of the
fan blade facing toward the rear grill, firmly onto the
motor shaft. Make sure that the fan blade rests on
the pin on the motor shaft.
NOTE: The shaft screw portion should protrude
from the front of the blade.
4. Secure the fan blade onto the motor shaft by
turning the blade cap counter-clockwise (make sure
the blade is firmly in position).
5. Center the front grill, ensuring the Bionaire™ logo is
horizontal and parallel to the floor, and press onto
rear grill after aligning snaps.
OPERATING
INSTRUCTIONS
1. Once unit is fully assembled and installed on the
wall, plug it into an appropriate electrical outlet.
2. Pull the RIGHT CONTROL CORD down or turn the
SPEED KNOB to select the desired fan speed or to
turn it off: "0" ifor "OFF", "1" for Low Speed, "2" for
Medium Speed and "3" for High Speed
(see figure 1).
3. To start or stop the head oscillation, pull the LEFT
CONTROL CORD down.
NOTE: CAREFULLY PULL ON FAN CORD
CONTROLS. EXCESSIVE FORCE MAY DAMAGE
FAN AND MAY CREATE AN ELECTRICAL
HAZARD.
4. Adjust the tilt of the fan head to the desired angle
by pushing gently up or down on the fan guard,
while holding the fan by the motor assembly. The
fan may be moved up and down, but not left to
right.
NOTE: THE FAN MUST BE FULLY ASSEMBLED
ON THE WALL BEFORE MAKING THIS
ADJUSTMENT; OTHERWISE THE FAN HEAD
BWLF1613MW-LA_13MLM1.indd 2
WILL NOT HOLD INTO POSITION.
CAUTION: THE FAN SHOULD BE SWITCHED
OFF BEFORE MAKING THIS ADJUSTMENT.
CLEANING AND
MAINTENANCE
Follow these instructions to correctly and safely care for
your fan.
•
Always unplug the fan before cleaning or
disassembling.
•
Be sure to clean your fan with a soft cloth
moistened with a mild soap solution.
•
Do not allow water to drip on or enter into the fan
housing.
•
Do not use gasoline, thinner, or benzene as a
cleaner.
•
Lightly run a vacuum cleaner nozzle over the fan
grill to remove any dust or dirt that may have
accumulated.
FAN BLADE CLEANING
INSTRUCTIONS
This fan is equipped with a removable grill that allows
the consumer to remove the grill and its components
without the need of any tools.
Make sure the fan is unplugged before disassembling
and cleaning the fan blade. Carefully remove the front
grill. Wipe the blade with a soft cloth moistened with a
mild soap solution. DO NOT allow any liquid to drip into
or enter the motor housing. Snap the front grill onto the
fan. Make sure all parts are secured prior to operating
the fan.
FAN STORAGE
When storing your fan please use the original box. It is
important to keep it in a safe, dry location.
•
Store your fan in the original box or an
appropriately sized box.
•
Protect the fan head from dust.
•
Store your fan in a dry location.
2
7/12/13 4:04 PM
Advertisement
