Sales Demo Mode - Whirlpool W11296289 Service Manual

Display Fail Message State Table
Display Information
D 9 D 8 D 7 D 6
□ □ Ƀ □
□ Ƀ □ □
Ƀ
□ □ □
Ƀ Ƀ
□ □
Ƀ Ƀ
□ □
Ƀ Ƀ
□ □
Ƀ Ƀ Ƀ
□
For Display Model Only:
For water filter indicator reset LED test, press and hold TEMP button for 3 seconds until the water filter LED blinks to verify LED
function.
For dispenser function, use the wiring diagram for reference to validate all connections and switch operation.
CUDA 17 IDI & DPLUS
Water Filter Reset & Showroom Mode
SHOWROOM Mode Use Case
To enter showroom mode
1. Within 2 minutes after power-
up, press and hold (RC & FC
TEMP keys) for 5 seconds.
Press (FC TEMP SETTING or RC TEMP
SETTING) key in the showroom
mode.
Press (LIGHT) Key in show room
Press (ICE TYPE) key in show room
mode.
For Service Technician Use Only
LEDs ON (No Blinking) when Illuminated
Main Board (Heater driver or compressor driver)
Refrigerator Sensor
Defrost Sensor
Refrigerator & Defrost Sensor
Main Board + Refrigerator Sensor
Main Board + Defrost Sensor
Multiple Failures (Sensors + Drivers)

Sales Demo Mode

The system enters in Showroom mode.
UI performs "showroom animation":
• All five LEDs (RC & FC TEMP LEDs) turn on one by one from
left to right and then right to left and keep cycling. (Cycling
rate: 1 cycle per second).
• Showroom mode does not activate sleep mode.
• If there is no user action during 2 minutes of showroom
mode, the animation will stop and then UI behaves (fake) as
normal mode.
• During the animation, if the user touches any key, the
animation will stop and UI behaves as a fake normal mode.
• During fake normal mode, after two minutes without user
interaction, the animation will start again to indicate that UI
is in showroom mode.
The recommended temperature setting (i.e. <colder>) is on.
Then UI behaves (fake) as normal mode if the user presses any
key again, except that cooling stays off in showroom mode and
no temperature setting is saved.
Behavior will be same as normal operation.
Ice-type LED changes between crush when the user presses the
Ice Type key.
System Feedback
Whirlpool , Maytag , Amana
® ®
DIAGNOSTICS
Reference
Fake normal mode is normal
mode with all cooling loads
off.
, & IKEA Refrigerators
® ®
n 2-9