English - AEG RSE 1400 Instructions For Use Manual

TECHNICAL DATA
Power (motor) ....................................................................................
Rate of air flow ..................................................................................
Vacuum ..............................................................................................
Capacity
Container ........................................................................................
Solid ...............................................................................................
Liquid ..............................................................................................
Filter surface ......................................................................................
Maximum power off-take ...................................................................
Suction hose diameter .......................................................................
Weight without cable .........................................................................
Typically the A-weighted sound pressure level of the tool is less
than 70 dB (A).
The noise level when working can exceed 85 dB (A).
Wear ear protectors!
SAFETY INSTRUCTIONS
Please pay attention to the safety instructions in the attached
leaflet!
Appliances used at many different locations including open air
must be connected via a current surge preventing switch.
Before doing any work on the machine, pull the plug out of the
socket.
Make sure the machine is switched off before plugging in.
Never suck up into the machine any inflammable or explosive
solvents, or liquids like petrol, oil, alcohol, thinners, or small
particles (such as metal filings or ash) that may be hotter than
60°C - otherwise there is danger of explosion or fire!
You are not allowed to use the appliance in the vicinity of
inflammable gases or substances.
Do not put appliances or accessories into operation, if: the
appliance has recognizable damage (cracks/breaks), the
mains connection lead is defective or shows signs of cracking
or aging, there is a suspected non-visible defect (after having
been dropped).
Do not point the nozzle, hose or tube at people or animals.
The plug socket on the appliance may be used only for the
purposes defined in the usage instructions.
If any foam or water egresses, switch off immediately. Empty
the container and, if need be, the pleated filter.
Acids, acetone and solvents can corrode the appliance
components.
In the event of misuse, improper operation or unprofessional
repair work no liability shall be assumed by us for any damage
incurred.
Do not use suction on health damaging dusts.
Not suitable for sweeping up liquids which form a large foam.
Make sure that the mains connection cable is not damaged,
squashed, bent, or damaged by being run over or in any other
way.
If the mains connection cable is damaged the machine must
not be used.
Extension cables to the mains must at least be protected from
water spray and contain an earth lead.
The machine is to be connected to the mains via an H 16A
contact-breaker or a 16A fuse.
SPECIFIED CONDITIONS OF USE
The vacuum cleaner can be used as follows: suction of non-
toxic dusts and non-cumbustible liquids, aspiration of sloppy or
muddy water, clearing up clogged drains, on-site cleaning
(building sites, working places, etc.).
Do not use this product in any other way as stated for normal
use.
15

ENGLISH

.. 1200 W max 1400 W .. 1200 W max 1400 W
...... 61 l/s ...... 61 l/s
.... 248 mbar
.... 248 mbar
...... 25 l ...... 25 l
...... 20 l ...... 20 l
...... 15 l ...... 15 l
.. 8600 cm
.. 8600 cm
2 2
.. 2000 W (Australia max. 1200 W)
.. 2000 W
...... 35 mm ...... 35 mm
... 11,5 kg ... 11,5 kg
CONNECTION WALL CHASER
Connect wall chaser with antistatic hose (available as
accessory) to avoid building up of charge.
EC-DECLARATION OF CONFORMITY
We declare under our sole responsibility that this product is in
conformity with the following standards or standardized
documents. EN 60 335, EN 55014-1, EN 55014-2, EN 61000-
3-2, EN 61000-3-3, in accordance with the regulations 73/23/
EEC, 89/336/EEC
Manager Product Development
MAINS CONNECTION
Connect only to a single-phase AC current supply and only to
the mains voltage specified on the rating plate. Must only be
used from sockets with earth wire
MAINTENANCE
Should the suction performance decrease in spite of automatic
filter cleaning, the filter cartridges must be either cleaned or
replaced (see section exchange of filter cartridges in
illustration).
Use only AEG accessories and spare parts. Should
components need to be exchanged which have not been
described, please contact one of our AEG service agents (see
our list of guarantee/service addresses).
If needed, an exploded view of the tool can be ordered. Please
state the Article No. as well as the machine type printed on the
label and order the drawing at your local service agents or
directly at: AEG Elektrowerkzeuge, Max-Eyth-Straße 10,
D-71364 Winnenden, Germany.
SYMBOLS
Please read the instructions carefully before
starting the machine.
Always disconnect the plug from the socket
before carrying out any work on the machine.
Accessory - Not included in standard
equipment, available as an accessory.
Volker Siegle