Table of Contents
Advertisement
What to do if...
Remedying small malfunc-
tions
If one of the following fault codes is displayed in the
multi-display during operation:
– Fault codeÅ 10 (Problems with water inlet),
– Fault codeÅ 20 (Problems with water drainage),
please have a look at the following table.
When the fault is remedied, press the cycle selection
button. The cycle will continue.
With other fault codes ("Å " followed by a number):
– Abort the dishwashing cycle.
– Switch the appliance off and on again.
– Re-set the dishwashing cycle.
If the fault is displayed again, please contact the
Customer Care Department and inform them of the
fault code.
Malfunction
The cycle indicator for the select-
ed dishwashing cycle is flashing:
fault code Å 10 is displayed in the
multi-display:
(Problems with water inlet)
The cycle indicator for the select-
ed dishwashing cycle is flashing,
fault code Å 20 is displayed in the
multi-display.
(Problems with water drainage)
Fault code Å 30 is displayed in
the multi-display.
The cycle is not starting.
28
Possible cause
Water tap is blocked with limescale
or faulty.
The tap is turned off.
The filter (where present) in the
threaded hose fitting on the tap is
blocked.
Filters in the base of the dishwash-
er compartment are blocked.
Water inlet hose
has not been correctly positioned.
The sink outlet is blocked.
Water drain hose
has not been correctly positioned.
The anti-flood system has been
triggered.
The mains plug is not
plugged in.
A fuse in the house's wiring system
is defective.
For dishwasher models with a start
delay timer:
A start time has been selected.
Remedy
Check the water tap and have it re-
paired if necessary.
Turn the tap on.
Clean the filter in the threaded hose
fitting.
Press the button for the commenced
dishwashing cycle;
then abort the dishwashing cycle
(see section: Starting a dishwashing
cycle);
clean filters (see section: Cleaning
the filters).
Check the position of the hose.
Clean out sink outlet.
Check the position of the hose.
First shut off the water tap, then
switch off the appliance and contact
the Customer Care Department.
Plug in mains plug.
Replace fuse.
If the dishes are to be washed im-
mediately, cancel the start delay tim-
er.
Advertisement
Table of Contents
