Table of Contents
Advertisement
General
• The dishwasher is supplied ready to be connected
to the electrical supply, i.e. with electrical cable, in-
stalled drain hose and inlet hose with filter.
• The dishwasher may be built into recesses made
of flammable materials without additional meas-
ures being taken.
• Tap and socket are to be made available as per the
diagram opposite.
• The regulations of the local water board and
electricity company must be observed.
Water installation
Inlet
• Water pressure: 1–10 bar (flow pressure)
• On the construction side a regulating tap with G 3/
4" outlet is to be provided.
• The appliance has to be connected to the water
supply with the plastic pressure hose which has
been supplied together with the appliance (plastic
pressure hose combined with filter, EN61770,
10 bar).
• Installation of an IRG filter is recommended on the
construction side.
Drainage
• The flexible drain hose with an inner diameter of
22 mm is to be laid with no kinks.
• A return inhibitor is integrated into the machine's
drainage and therefore connection fittings with
non-return valves are not necessary.
• The preferred connection is via the siphon of the
sink outlet next to the machine.
• The highest point of the drain hose is not to be
more than 600 mm above the floor.
34
A = drain outlet
G = size of appliance
K = cold water supply
N = size of recess
W = hot water supply
E = socket
Advertisement
Table of Contents
