Connecting The Hose - Invacare microAIR MA90 Series Owner's Operator And Maintenance Manual

SECTION 2—OPERATION

Connecting the Hose

Ensure that the hose connecting the control unit to the mattress is routed such that
it cannot be stepped on, kinked, squeezed or otherwise damaged.
NOTE: For this procedure, refer to FIGURE 2.3.
1. Locate the hose at the foot end of the mattress.
2. Locate the control unit connector on the right side of the control unit.
3. Perform one of the following:
• MA90Z ‐ Perform the following steps (Detail "A"):
i. Squeeze and hold the tabs on the hose connectors.
ii. Insert the hose connectors into the control unit connector.
iii. Push the hose connectors onto the control connector until an audible click is
heard.
NOTE: The audible click indicates that the hose connector(s) are properly engaged with the
control connectors.
• MA95Z ‐ Perform the following steps (Detail "B"):
i. Lift and hold the connector cover up .
ii. Push the hose connector onto the control connector .
iii. Ensure the hose connector is flush with the control unit connector.
MA90 Series
CAUTION
12
Part No 1148139