Programming The Automatic Wireless Fowler Transmitter - Invacare microAIR MA90 Series Owner's Operator And Maintenance Manual

Programming the Automatic Wireless Fowler Transmitter

1. Ensure the transmitter is inside the mattress pocket located on the right side of the
mattress at the head end.
2. Ensure the mattress is in a flat position.
3. Ensure the control unit is plugged in, and the LCD displays STAND BY.
4. Perform one of the following:
• MA90Z ‐ Perform the following steps:
i. Press and hold the Turn Angle and Max Inflate buttons.
NOTE: The Fowler LED is lit and L displays in the LCD Display.
ii. Raise the bed to 45°.
NOTE: The control unit will beep and will return to Standby.
iii. Perform one of the following:
• Cancel ‐ Press the Turn Angle button to exit Fowler Transmitter Setup
without linking to a transmitter.
• Save ‐ Wait 60 seconds without pressing a key.
• MA95Z ‐ Perform the following steps:
i. Press and hold the Hold and Max Inflate buttons.
ii. AUTO FOWLER LEARN MODE will display.
iii. PLACE BED IN FLAT POSITION will display.
iv. CONTINUE ‐> SELECT will display.
v. Press the Select button.
vi. PLACE BED IN FOWLER/UPRIGHT POSITION will display.
vii. TRANSMITTER DETECTED will display.
viii.The control unit will beep.
ix. STAND BY will display.
Part No 1148139
SECTION 2—OPERATION
17
MA90 Series