Installing The Control Unit; Connecting The Hose - Invacare MicroAir MA60 User Manual

6 OPERATION
6.3

Installing the Control Unit

1. Pull out the bed hook on the back of the control unit.
2. Place the control unit on the footboard.

If the bed does not have a footboard, place the control unit on a flat surface, leaving room for the hose to hang down.
6.4

Connecting the Hose

CAUTION
Ensure that the hose connecting the control unit to the mattress is routed such that it cannot be stepped on, kinked,
squeezed or otherwise damaged.

For this procedure, refer to FIGURE 2 on page 19.
1. Locate the hose at the foot end of the mattress.
2. Locate the control unit connectors on the right side of the control unit.
3. Squeeze and hold the tabs on the hose connectors.
4. Insert the hose connectors into the control unit connectors.
5. Push the hose connectors into the control connectors until an audible click is heard.

The audible click indicates that the hose connectors are properly engaged with the control connectors.
Invacare®MA60 Series
18
Part No 1148137