Prepare the worktop
Create the worktop cut-out as shown
in the hob and inset diagrams.
Remember to maintain the minimum
safety distances (see "Safety
distances").
Solid wood, tiled and glass worktops:
Fix a wooden frame 7 mm below
the top edge of the worktop (see
diagram).
Connect the mains connection cable
to the appliance
The mains connection cable must
only be connected by a suitably
qualified and competent person.
Follow the instructions in the wiring
diagram (see "Electrical connection -
Wiring diagram").
Install the hob
Feed the mains connection cable
down through the cut-out.
Centre the hob in the cut-out.
Connect the hob to the mains.
Check that the hob works.
Seal the remaining gap with a
silicone sealant that is heat-resistant
to at least 160°C.
Unsuitable sealant can damage
natural stone.
For natural stone worktops and
natural stone tiles, only use silicone
sealant that is specially formulated
for natural stone.
Please follow the manufacturer's
instructions.
Flush-fitted hobs
71