Sony HDC2500 Operation Manual page 15

e SDI 1 (serial digital interface 1) connector (BNC-type)
(HDC2500/2400)
For 3G-SDI, HD-SDI or HD PROMPTER signal output.
Note
HD PROMPTER signal output only when <CAM MODE> is set
to 4K/HDR MODE. Set <CAM MODE> to NORMAL as
necessary.
For details on the output signals, see "Setting the Camera
Outputs" (page 31).
f SDI 2 (serial digital interface 2) connector (BNC-type)
(HDC2500/2400)
For HD-SDI signal output or HD TRUNK signal input. During
stand-alone operation, also used for inputting an HD-SDI
return signal. When RET (return) is set to 1, this is displayed
in the viewfinder.
Note
This connector is disabled when <CAM MODE> is set to 4K/
HDR MODE. Set <CAM MODE> to NORMAL as necessary.
For details on the output signals, see "Setting the Camera
Outputs" (page 31).
g PROMPTER2 connector (BNC-type) (HDC2500/2400)
For prompter 2 signal output
Available only when connecting a camera control unit with a
prompter 2 input connecter.
During stand-alone operation, also used for inputting a VBS
return signal. When RET (return) is set to 2, this is displayed
in the viewfinder.
g SDI 1 (serial digital interface 1) connector (BNC-type)
(HDC2570)
For 3G-SDI or HD-SDI signal output.
h CALL button
When this button is pressed, the red tally lamp of the RCP-
1000-series Remote Control Panel or the MSU-1000-series
Master Setup Unit will light. Use to call the operator of the RCP
or MSU.
Operation panel
SY type:
For JN/SY/UC (USA, Canada, East Asia and other
countries) models (for NTSC areas)
For details on the differences among models, see "Overview"
on page 3.
2
RET1
1
PGM1
LEVEL MIC
REAR ON
FRONT OFF
INTERCOM 1
a
PGM1 control
PGM1
LEVEL MIC
INCOM
REAR ON
FRONT OFF
INTERCOM 1
INCOM level control
LEVEL/MIC switch
a INTERCOM1 and INTERCOM2 controls and switches
There are PGM1 and 2 controls incorporated with a line select
switch, a LEVEL/MIC switch, and INCOM level control each
for intercom line 1 and 2.
PGM1 (program 1) control
Adjust the audio listening level of program 1.
PGM2 (program 2) control
Adjust the audio listening level of program 2.
LEVEL/MIC switch
REAR/ON: The intercom headset microphone is turned on.
The intercom audio listening level is adjusted with the
INCOM level control.
REAR/OFF: The intercom headset microphone is turned off.
The intercom audio listening level is adjusted with the
INCOM level control.
15
3 4
2 3 RET2 2 3
LIGHT
1
4 4
ON
OFF
PGM2 PGM1 PGM2
LEVEL MIC
PROD PROD
INCOM INCOM
REAR ON
ENG FRONT OFF ENG
INTERCOM 2
PGM2 control
PGM2 PGM1 PGM2
LEVEL MIC
PROD PROD
INCOM
REAR ON
ENG FRONT OFF ENG
INTERCOM 2
Line select switch