Advertisement
Specifications
Battery: Panasonic CR123A, Duracell DL 123, Duracell DL 123A, Honeywell 466
Tamper: Cover and Wall
RF Frequency: 2.4GHz
Operating Temperature: 0° to 50° C / 32° to 122° F
Relative Humidity: 5 – 95%, non-condensing
Dimensions: 96 mm Diameter x 29mm Thick / 3.78" Diameter x 1.14" Thick
Protected Glass Types Chart
NOTE: The RF6GB is NOT recommended for protection of glass areas smaller than 27.6 cm x 27.6 cm (10-7/8 inches x 10-7/8 inches).
Glass Type*
Plate
Tempered
1, 3
Laminated
Wired
2, 3
Coated
1,3
Sealed Insulating
*
Minimum size for all types is 28cm (11 in.) square; glass must be framed in the wall or mounted in a barrier at least 0.9m
(36 in.) wide.
1
Protected only if both plates in the unit are broken
2
Coated glass with security films up to 0.35mm (14 mils) thick (including films for solar protection) may be used. Evaluated with the these products:
®
®
3M
SCOTCHSHIELD
SH14CLARL – 0.35mm (14 mils), 4 ply film; Film Technologies International, Inc.'s GLASS-GARD GGLL 1200 has been evaluated
with this product by Underwriters Laboratories, Inc.
3
In compliance with Underwriters Laboratories of Canada's Standard for Intrusion Detection Units (CAN/ULC-S306-M89):
a. Plate glass 3mm (1/8-in.) to 10mm (3/8-in.) can be used.
b. ULC recognizes a maximum range for protecting sealed insulating glass, 1/8" laminated and coated glass of 3.8m (12.5 ft.); sensitivity should be set
to High.
FEDERAL COMMUNICATIONS COMMISSION & INDUSTRY CANADA STATEMENTS
The user shall not make any changes or modifications to the equipment unless authorized by the Installation Instructions or User's Manual. Unauthorized
changes or modifications could void the user's authority to operate the equipment.
FCC / IC STATEMENT
This device complies with Part 15 of the FCC Rules, and RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
Cet appareil est conforme à la partie 15 des règles de la FCC & de RSS-210 des Industries Canada. Son fonctionnement est soumis aux conditions suivantes:
(1) Cet appareil ne doit pas causer d'interférences nuisibles. (2) Cet appareil doit accepter toute interférence reçue y compris les interférences causant une
reception indésirable.
RF Exposure
Warning –
The antenna(s) used for this device must be installed to provide a separation distance of at least 7.8 inches (20 cm) from all persons and must
not be co-located or operating in conjunction with any other antenna or transmitter except in accordance with FCC multi-transmitter product procedures.
Mise en Garde
Exposition aux Frequences Radio:
(20 cm) de toutes les personnes
REFER TO THE INSTALLATION INSTRUCTIONS FOR THE CONTROL WITH WHICH THIS DEVICE IS USED, FOR DETAILS REGARDING LIMITATIONS OF
THE ENTIRE ALARM SYSTEM.
For the latest U.S. warranty information, please go to www.honeywell.com/security/hsc/resources/wa or
Please contact your local authorized Honeywell representative for product warranty information.
2014 Honeywell International Inc. Honeywell and is a registered trademark of Honeywell International Inc.
All other trademarks are the properties of their respective owners. All rights reserved.
www.honeywell.com/security
[PRELIMINARY – TBD AFTER AGENCY TESTING]
Minimum
2mm (3/32 in.)
3mm (1/8 in.)
3mm (1/8 in.)
6mm (1/4 in.)
3mm (1/8 in.)
3mm (1/8 in.) [13mm (1/2 in.) overall]
L'antenne (s) utilisée pour cet émetteur doit être installée à une distance de séparation d'au moins 7,8 pouces
.
Nominal Thickness
6mm (1/4 in.) [19mm (3/4 in.) overall]
Support and Warranty
2 Corporate Center Drive, Suite 100
P.O. Box 9040, Melville, NY 11747
Approval Listings
RoHS
FCC / IC
ULC S306-03
UL 639
Maximum
10mm (3/8 in.)
10mm (3/8 in.)
14mm (9/16 in.)
6mm (1/4 in.)
6mm (1/4 in.)
DOC CODE 128B BAR CODE HERE
P/N 800-19202GB 01/15 Rev BETA
Advertisement
