Advertisement
SIXSIREN LEDs and Sounder
Refer to the table below for operation of the four bi-colored LEDs and an 85dB sounder.
R / W
Red ON for 20 seconds
Alternating Red and White
Flashing Strobe
1
(continues
until the Alarm is cleared)
White Strobe Flashing
Red flashes once
every 45 seconds
1
Strobe flash = two flashes per second, then OFF for 1 second.
2
It is best to replace the battery BEFORE the chirping begins. Once started, the sounder continues to chirp until batteries are
replaced or die. See the Battery Replacement section.
Specifications:
Battery: Four AA Lithium, Non-Rechargeable; Honeywell 462
Tamper: Cover tamper
RF Frequency: 2.4GHz
Operating Temperature: 0° to 50° C / 32° to 122° F
Relative Humidity: 95% max. (Agency compliance – 93% max), non-condensing
Dimensions: 14.14 cm Diameter x 4.62 cm Thick /
5.5 in. Diameter x 1.8 in. Thick
Weight:
xx
oz
(xx
g)
G / W
Green Rapid Flashes for
about 20 seconds, then ON
for 3 seconds
Green Slow Flashing for 3
seconds
Green ON for 20 seconds
White Strobe Flashing
Green Flashes slowly
for 10 minutes
Sounder
Status
Power Up – Enrollment
Chirps once
Power Up – Device enrolled
Chirps once
System is Disarmed
System is Armed
Burglary
Smoke or CO Alarm
Warble ON for
3 seconds
Burglary
Burglary Alarm
Warble ON for
3 seconds
2
Low Battery
Tamper Activated
Approval Listings:
FCC / IC
ETL Listed to UL985 / UL1023
cETL Listed to ULC-S545 &
ULC/ORD-C1023
RoHS
Advertisement
