Operation - HBC-Radiomatic Cubix Operating Instructions Manual

Operating Instructions
Radio Transmitter cubix
BE-CUBIX_V1.3-FCC.doc.DOC [ Word 2000 ] MB
3
Caution :
The operation of the transmitter is permissible only with the carrying set included with
the transmitter (possibility of mixing up the operator controls) !
Switching ON the Transmitter
1. Before
operation, be sure that the transmitter is fully charged.
The battery supplies the necessary working voltage (3.6
V DC).
2. Press the START pushbutton to the 1
and release it.
3. Within the next 6 sec press the STOP pushbutton (pos.
ℑ) to the 2
4. Follow by pressing again the START pushbutton
(pos.ℵ) to the 1
The dual color LED (pos. ℜ) flashes green and a beep
5.
will appear, i.e. the transmitter is operable.
While activating the commands the green LED is flashing
very fast (5 times per sec.). After releasing the pushbuttons
and without giving any other command the LED will turn to
flash slowly (1 time per sec.) for being in Energy-Safe-
Mode. By pressing any pushbutton the command will be
transmitted immediately, and the status of the green LED
will turn to fast flashing.
Important Information :
After switching ON the transmitter and before operating
the crane or machine you must always :
– trigger the acoustic signal by pressing the "Horn"
pushbutton. This warns all colleagues that the crane
or machine is about to move;
– test the operativeness of the STOP pushbutton.
A radio connection to the receiver is established when the red LED "HF/RF/H.F./HF" on
the receiver will be extinguished and the green LED "Si1" is illuminated (see radio status
panel of the receiver), i.e. the radio system is ready to operate and the control
commands may be activated by the transmitter.
Status of the LED (pos. ℜ) while working / switching on:
The dual color LED flashes green:
The dual color LED flashes red:
The dual color LED flashes red together with a beep:
HBC-radiomatic GmbH • D-74564 Crailsheim • Germany
Information and specifications subject to change without notice.

Operation

commissioning the
nd
step and release it too.
s t
step and release it.
transmitter or initial
st
step (pos.ℵ)
The transmitter is operable.
Battery is on low voltage. Only one hour max.
till the transmitter shuts down completely.
Battery is almost discharged. In approx. 10 min
The transmitter will shut down completely.
Page 9 / 18
ℜ
ℵ ℑ
Radio Control System
2003-03-11