Operator Safety Instructions - HBC-Radiomatic Cubix Operating Instructions Manual

Radio transmitter

Hide thumbs

Table Of Contents

Table of Contents

Operating Instructions

Radio Transmitter cubix

BE-CUBIX_V1.3-FCC.doc.DOC [ Word 2000 ] MB

2.3

Before beginning crane operation, position yourself so that you have a clear and

complete overview of the working radius of the crane or machine.

To operate, hold the transmitter securely in your hand. Use the optional belt-clip.

Follow these instructions to ensure personal safety.

Depending on your angle or position to the crane or machine, the transmitter control

commands "trolley left" and "trolley right" appear to interchange ! It is essential that

you take your bearings to the crane or machine into due consideration before

operating equipment.

In case of an emergency or any disturbances within the working range of the crane

or machine, switch the transmitter off immediately by pressing the STOP

pushbutton. Should the transmitter show signs of technical failure or breakdown,

disconnect the radio control system immediately !

Switch the transmitter OFF during breaks and after finishing work to avoid any

misoperation of crane or machine by unintended activation of the operator controls.

–

Never leave an activated transmitter unattended. The operator undertakes to follow

and comply with the authoritative regulations for worker safety and accident

prevention (e.g. VBG 9).

Note :

–

In the event of an interruption of the radio link during a working cycle – what can

occasionally happen – both transmitter and receiver automatically shut down (so-

called "compulsory switch-off").

To reactivate the system release all operator controls, such as pushbuttons or

momentary contacts, and allow the control elements to return to their zero

position. Press the "Start" pushbutton. The system must be reactivated before the

crane or machine can react to control commands! This feature hinders any

uncontrolled or unwanted crane or machine movement, should the radio link be

interrupted.

–

When operating a crane by means of a radio control system for the first time, you

may miss the physical contact to the crane that you were used to in the operating

stand. As you are no longer in the crane and can no longer sense the starting of

the crane movements as distinctly, crane reactions will appear sluggish or dull.

HBC-radiomatic GmbH • D-74564 Crailsheim • Germany

Information and specifications subject to change without notice.