Sharp R-23AT Original Instruction page 16

COUNTER RESET
Each number of times can be cleared.
Example : Suppose you want to clear the times of memory 1.
Step
1 Choose checking mode.
2 Choose the memory 1.
3 Clear times of using the memory 1.
4 Cancel checking mode.
NOTE:
1. To clear times of manual cooking, touch MANUAL/REPEAT key (
To clear times of Defrost cooking, touch EXPRESS DEFROST key (
2. To clear total using times, skip step 2.
INFORMATION WITH ERROR MESSAGES
If ERROR messages are displayed, follow the below instructions.
ERROR MESSAGES
EE1, EE2, EE3,
EE6, E10, EE16
EE8,EE0 (For R-23AT)
EE19 (For R-25AT )
EE7
EE9
EE17
INFORMATION WITH FILTER INDICATOR
Clean the air intake fi lter when the FILTER indicator lights up (See page GB-17.). The FILTER indicator will light
up when the oven has been operated for about 200 hours in total.
To cancel FILTER indicator touch the START key (
matically again when the FILTER indicator is canceled.
Action
Please contact your dealer or an authorized Sharp service agent because the oven
must be out of order.
Exhaust air temperature is too high. Checking that nothing is blocking the ventilation
openings or that room temperature is very hot or that oven cavity is empty during opera-
tion. Correct, touch STOP/CLEAR key (
The time you set exceeds a maximum time. Touch STOP/CLEAR key (
enter appropriate time.
Magnetron temperature is too high, touch STOP/CLEAR key (
after a few minutes.
Press Key
X 2
1
) at step 2 instead of NUMBER key.
) and try again after a few minutes.
). The oven will start to count the operation time auto-
GB-15
Display
CHECK will fl ash on and off.
(Total count)
NUMBER
(Times memory 1 used)
NUMBER
) at step 2 instead of NUMBER key.
) and try again
CHECK
CHECK
CHECK
) and