Table of Contents
Advertisement
Changing the selections after the
program has started
Turning the program knob while the program is in a
normal flow will not change the program.
Switching the machine to standby mode
Press "Start/Pause/Cancel" button momentarily
to switch your machine to the standby mode.
Auxiliary functions can be cancelled or selected in
accordance with the step the program is at. The
door can be opened if the water level is suitable.
Laundry may be added / taken out by opening the
door.
Door lock
The loading door can not be opened yet due to
safety reasons while the "Ready" lamp is flashing.
The loading door can be opened once the "Ready"
lamp starts lighting up continuously.
Child-proof lock
You can protect the appliance from being
tampered by children by means of the child-proof
lock. In this case, no change can be made in the
running program.
C
Your machine can be turned on and off with
On/Off button while the child-proof lock is
activated. In this case, your machine will
resume its program with child-proof lock
activated.
The machine is switched to child-lock by pressing
the 1st and 2nd auxiliary functions for 3 sec. "C
on" (Child lock is activated) label appears on the
screen. The same symbol will also be displayed
whenever any button is pressed while the machine
is child-locked.
Child-proof lock lamp on the program follow-up
indicator will light up when the child-proof lock is
activated.
To deactivate the child-proof lock, press the 1st
and 2nd auxiliary function buttons for 3 sec. "C
OFF" (Child-proof lock is deactivated) symbol
appears on the screen. Child-proof lock lamp on
the program follow-up indicator will go off when the
child-proof lock is deactivated.
Ending the program through
canceling
"Start/Pause/Cancel" button is pressed for 3
seconds to cancel the program. "Ready" warning
lamp flashes during canceling and "End" will
appear on the display.
5 Maintenance and cleaning
Detergent Drawer
Remove any powder residue buildup in the drawer.
To do this;
1. Press the dotted point on the siphon in the
softener compartment and pull towards you
until the compartment is removed from the
machine.
If more than a normal amount of water and
C
softener mixture starts to gather in the softener
compartment, the siphon must be cleaned.
2. Wash the dispenser drawer and the siphon
with plenty of lukewarm water in a washbasin.
3. Replace the drawer into its housing after
cleaning. Check if the siphon is in its original
location.
Inlet water filters
There is a filter at the end of each water intake
valve at the back side of the machine and also
at the end of each water intake hose where they
are connected to the tap. These filters prevent the
foreign substances and dirt in the water to enter
into the machine. Filters should be cleaned as they
get dirty.
• Close the taps.
• Remove the nuts of the water intake hoses to
clean the surfaces of the filters on the water
intake valves with an appropriate brush.
• If the filters are very dirty, you can pull them out
by means of pliers and clean them.
• Take out the filters on the flat ends of the water
intake hoses together with the gaskets and
clean thoroughly under streaming water.
• Replace the gaskets and filters carefully to their
places and tighten the hose nuts by hand.
Draining any remaining water and
cleaning the pump filter
Your product is equipped with a filter system which
ensures a cleaner water discharge that extends
pump life by preventing solid items such as
9 - EN
Advertisement
Table of Contents
