Indicator Light - PROCRAFT 511307 Operating Instructions Manual

3
1
5
6
7
8
7
6
9
" Mode Selector :
1. "
2
9
1 1 0
2
3
4
3
11
12
5
Choosing MIG, MMA, TIG Welding
according the work needed.
" MIG welding: when you
4
chose this welding mode, please
plug the welding plug with cable to
the MIG control socket 10 and plug
the earth cable to socket 8. (Refer to
page 9, (1)).
" " MMA welding: when you
chose this welding mode, please
connect the MMA welding plug and
earth cable plug to socket 8 or 9.
They can be exchanged. (Refer to
page 9, (1)).
" TIG welding: when this TIG
"
welding mode is selected, please
connect the TIG torch control cable
in to TIG control socket 8 and
connect the earth cable to the socket
2. " ""

Indicator Light.

welding operation.
3. " "Thermal Overload Indicator
Lamp. This light will come on, and the
device will shut down if the tool
becomes overheated. Stop trying to
use the cutter while leaving the power
switch onto allow the cooling fan to
operate, and the lamp will turn off
automatically when the machine cools
down.
Please pay attention to the Rated
Duty Cycle discussed on page 11.
4.
Manual wire feeding:
The welder begins to feed the wire,
when this button is pressed and the
"Working
It will be on during
Page 12