Regulations Important Safety Instructions Please read the following precautions before use: FCC Statement and Warning 1. Read these instructions. 12. Use only with the cart, stand, tripod, bracket or table specified by the manufacturer or sold with the This equipment has been tested and found to comply with 2.
Bi-amplification – The Harman Kardon Go + Play II unit utilizes two amplifiers to allow for clean, powerful sound output. RF remote – Allows for control of the Harman Kardon Go + Play II system from up to nine meters (29 feet) away.
Storing Your Smart Remote Battery Disposal The Harman Kardon Go + Play II system is equipped with a storage compartment on the back of Alkaline batteries are considered nonhazardous. Rechargeable batteries (i.e., nickel cadmium, the unit. Simply press the compartment to open it and store your remote.
Page 5
Go + Play II system, with an iPhone/iPod docked, to iTunes To turn the unit off: Press and hold the “Play/Pause” button. and provides a charge to the iPhone/iPod even when the Harman Kardon Go + Play II is only To scroll the iPod cursor up: Press the “Reverse” button.
EQ be set to “Flat” or “Off.” Turn up the volume. Check the unit with a known Harman Kardon Go + Play II Input cable is not plugged Check input cable connection. good source. unit emits a loud hum or in properly.
Technical Specifications Model: Harman Kardon Go + Play ™ Symptom Possible Problem Solution Note Available in: Black Charging Requirements: iPhone/iPod with docking connector; iPhone/iPod will not charge. No power to unit. Make sure that your the 3.5mm output jack for other devices wall outlet or power strip has power.