Verity Medical NeuroTrac Continence Operation Manual page 11

Setting up the Customised Programme PC1, PC2 or PC3
(Work/Rest)
Select PC1, PC2 or PC3 by pressing the PRG button on the front panel.
1. Press and hold the SET button for 3 seconds until Hz symbol will flash
on the display, then press the + or – button to adjust the pulse rate from
2-100Hz.
2. Press the SET button again and the µs symbol will flash on/off, then
press the + or – button to adjust the pulse duration from 50 - 450µs.
3. Press the SET button again and the Clock [Time] symbol will flash on/
off, then press the Channel A +/- button to alter the hours and Channel B
+/- button to adjust minutes.[Maximum time 1 hour 30 minutes].
4. Press the SET button again and the WRK [Work] symbol will be
displayed, then press the + or – button to adjust the work period
from 2– 99 seconds.
5. Press the SET button again and the RST [Rest] symbol will be displayed,
then press the + or – button to adjust the rest period 2 – 99 seconds.
6. Press the SET button again and the RMU [Ramp up] symbol will be
displayed, then press the + or - button to adjust the ramp up period from
0.1 - 9.9 seconds.
7. Press the SET button again and RMD (Ramp down) symbol will be
displayed, then press the + or - button to adjust the ramp down period
from 0.1-9.9 seconds.
8. Press the SET button again and SYN (Synchronous) symbol will flash
on/off. This is recommended for pelvic floor disorders. If you have been
advised to use ALT (Alternating) mode, press + or – button to select
ALT. Otherwise leave as SYN and go to next mode.
9. Press the SET button again. If SYN is selected in point 8, the DLY (Delay)
symbol will flash on/off. Press the + or – button to adjust the delay time
0-4 sec. For typical use, leave 0 seconds. If the delay is set above zero,
the channel 2 will ramp up with the delay.
After setting up the programme, press the ESC button to install and store the
customised programme. Repeat the above procedure to re-programme.
Note: You must press the ESC button before locking the unit.
NeuroTrac Continence Operation Manual
®
11