Safety 1st onBoard 35 Manual page 25

4358-4805B US onBoard 35 11/22/10
E-6 Installing Carrier with
Vehicle Belts
1.
2.
3.
47
3:26 PM Page 49
Place Child Restraint in
Vehicle Rear-Facing
Center the base in the
chosen seating position.
Check the angle indicator.
The ball should be between
the two marks on the
indicator that matches the
weight of your child.
NOTE: Check the angle
indicator while parked on
level ground.
Thread Vehicle Belt
Thread vehicle lap belt
through the belt path (as
shown). Buckle the vehicle
belt.
With an ALR belt, pull the
belt all the way out before
threading.
Tighten Vehicle Belt
Lay your forearm across
child restraint at the belt
path while pulling up on belt
to tighten. Feed the slack
back into the retractor while
tightening.
4. Check the Angle
Indicator
The ball should be
between the two marks on
the indicator that matches
the weight of your child.
NOTE: Check the angle
indicator while parked on
level ground.
5. Check Vehicle Belt
Tightness
Grasp the child restraint
at the belt path with one
hand. Push and pull the
child restraint from side to
side, forward and back.
The child restraint should
not move more than 1
inch.
NOTE: If carrier moves
more than 1 inch, try
reinstalling the base or try
another seating location.
48